Screw Peg Install
Step 1
Remove pad from peg
-
Remove the 2 screws from the bottom holding the highway peg pad to the peg bracket (These bolts can be discarded. They will not be reinstalled)
Step 2
Connect the dowel screw
-
Thread the included rivet nut on to the dowel screw
Step 3
Prepping the Rubber Foot Peg
-
Using plyers or channel locks, screw the dowel screw in to the rubber foot peg
Step 4
Drill the foot peg bracket
-
Use 3/8 Drill and drill bit to drill out the holes on the foot peg bracket to accommodate the new mounting hardware.
Step 6
-
Reinstall the rubber foot pad on to the peg bracket, adding the new highway peg bracket to the bottom of the peg.
Fasten it to the peg using the ¼ inch hardware (flat washer, lock washer, nut) that we have included for you.
Step 8
Mount Highway Peg Arm
-
Insert the 3/8 button head bolt in to the highway bracket
-
Followed by 2 washers
-
Followed by the highway peg arm
-
Followed by the 2 smaller washers
-
Lock in with 2 lock washers
-
Followed by the 2 acorn nuts
-
Tighten hardware using 5.5 mm Allen and a 5/8 Wrench
Side Note : The arm is reversible. You can install the arm with the arm arch up or the arm arching down
Step 9
Install the Peg
-
Bolt peg to the top of the highway peg arm
Step 10
Adjust Peg as needed
-
Sit on bike add place foot on peg to determine if you need to adjust the peg for comfort
Side Note:You may have to adjust again once you’ve rode the bike around a few times
Once again thank you for your purchase! If you need any help please give us a call.