Bolt Peg Install
Step 1
-
Remove the 4 Screws from the bottom of the floorboard, holding the rubber foot pad to the floorboard (Using T25 bit) . (These screws will be reinstalled later)
Step 2
-
Place the included template into the floorboard. Template is marked left and right for each side of the bike
Step 3
-
Mark the holes that will need to be drilled, with either a punch, marker or start a small hole
Step 4
-
Drill out he 2 holes using a 5/16 drill bit . Then vacuum or blow out the metal shaving
Step 4
Mounting the highway peg bracket
-
Insert the included 2x 5/16 button head bolts along with the 5/16 flat washers into the new holes in the floorboard
-
Hold the highway peg bracket in place why you install 2 more 5/16 flat washers followed by two 5/16 nylon lock nuts
-
( Highway peg brackets are mark left and right the slotted hole should be towards the back of the bike)
-
Go ahead and tighten up the bolts up using 3/16 Allen wrench and 1/2 wrench
-
Keep in mind you may want to adjust the bracket later to find your perfect position, DON'T FORGET TO TIGHTEN THE BOLTS ALL THE WAY BEFORE TAKING A TEST DRIVE
Step 5
Mount Highway Peg Arm
-
Insert the 3/8 button head bolt in to the highway bracket
-
Followed by 2 washers
-
Followed by the highway peg arm
-
Followed by the 2 smaller washers
-
Lock in with 2 lock washers
-
Followed by the 2 acorn nuts
-
Tighten hardware using 5.5 mm Allen and a 5/8 Wrench
Side Note : The arm is reversible. You can install the arm with the arm arch up or the arm arching down
Step 6
Install the Peg
-
Bolt peg to the top of the highway peg arm (6mm Allen wrench)
Step 7
Reinstall the rubber foot pad back on the floorboard reusing the four T25 screws
Step 8
Adjust Peg as needed
-
Sit on bike and test foot on pegs to determine if you need to adjust the peg for comfort
Side Note:You may have to adjust again once you’ve rode the bike around a few times
Once again thank you for your purchase! If you need any help please give us a call.