Universal Dual Graph Mount
Back to Back
DO NOT USE AND IMPACT DRIVER TO INSTALL ANY OF THE HARDWARE
STEP 1
Unbox and lay out all the parts and hardware
-
Top Plate
-
2x Arms
-
4x 1/4x.75” Bolts, Washers, Nuts (Used to assembly Graph Mount)
-
4x 1/4x1” Bolts, Washers, Nuts (Used to fasten electronics gimbals bracket to graph mount)
-
8x #12x1-3/4" Phillips Pan Head Stainless Steel Screws(Used to fasten mount to floor)
_JPG.jpg)
STEP 2
Determine Arm Mounting ​
-
The arms can be mounted to the top plate in two different ways, with the mounting holes facing either inward or outward. This allows for varying widths of the final mounting holes
STEP 3
Attaching Arms
-
Use the 4x 1/4x.75” Bolts, Washers, Nuts To bolt the arms to the Top Plate
-
The Arms should be mounted to the inside of the top plate.
-
The Bolt should come in from the outside go thur the top plate, then arm, and finished with a washer and nylon lock nut.
STEP 4
Attaching Gimbal Mounts
-
Use the 4x 1/4x1” Bolts, Washers, Nuts to attached gimbal mounts to top plate
STEP 5
Fasten To Boat
-
Use 8x #12x1-3/4" Phillips Pan Head Stainless Steel Screws To Fasten Graph Mount To Boat Deck.
